Clipping cloner to sweep

smckenzie

Ok, next challenege here. Similar to what we've discussed before

In this instance I have a profile swept along a spline which is then added to a cloner to replicate cladding on a wall.

Is there a way that that cloner could then be clipped to another shape/spline?

Dr. Sassi

It is more complex than the question before.
Why should there be a solution when there wasn't one for a simpler case?

I have written another reply to the original post.

IfSplines are used as a mask, then they do it in one direction. But please check out the reply in the other thread.

CINEVERSITY